Everything below concerns lyophilised powder. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Linear tetrapeptide, also written AEDG |
| Molecular mass | About 390.35 g/mol | Value calculated from the sequence |
| Appearance | White to off-white powder | Lyophilised material forms a loose cake |
| Solubility | Freely soluble in water | Also dissolves in isotonic saline |
| Storage | -20 °C, desiccated | Aliquot solutions to avoid freeze–thaw cycling |
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Freeze-dried epitalon is normally kept at minus twenty degrees Celsius in a sealed, desiccated container, protected from light. Short excursions at ambient temperature during shipping are generally tolerated, but repeated warming and cooling cycles encourage moisture uptake, which shortens shelf life. Once dissolved, the peptide is far less stable than the solid: aqueous solutions are subject to hydrolysis and to deamidation at the aspartate and glutamate residues. Working solutions are therefore held refrigerated and used within days, and repeated freezing and thawing of the same vial is best avoided.
Identity and purity are checked by reversed-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, where the peptide bond absorbs. Mass spectrometry confirms the expected mass and reveals whether truncation products or adducts are present. Acid hydrolysis followed by amino acid analysis gives the residue ratio, which should approximate one alanine, one glutamate, one aspartate and one glycine. Counter-ions such as acetate or trifluoroacetate remain in the dried product and lower net peptide content, so a stated purity figure on a label does not by itself describe how much peptide a vial holds.
Tissue engineering aims to generate functional constructs which could replace or improve damaged or infected tissues or whole organs. Many of these constructs lead to infected tissue around the implant area. Coating these materials in amylopectin allows reduction in this infectious reaction. Since amylopectin is mainly used as a coating around these constructs in as it prevents following immune reactions. Since amylopectin is derived directly from a natural polysaccharide, it integrates well with tissues and cells. However, mechanical properties of amylopectin are not optimal due to its high level of crosslinking. This can be avoided by the formation of amylopectin fibers or by forming a nanocomposite with another more rigid polymer.
Outbreaks of disease Food-born illness Bioterrorism Natural disasters APHL plays a critical role in crisis response to these public health emergencies through the Laboratory Response Network (LRN). The LRN was formed in 1999 in a cooperative effort between APHL, the CDC and FBI to rapidly detect, and respond to public health emergencies. The Department of Defense has joined in the effort to support biological response activities. In addition to their leadership during times of crisis, APHL has a strong focus on preparing public health laboratories on how to respond to emergencies when they happen through training and capacity-building, as well as creating model frameworks that labs around the country can use in order to have procedures in place to handle a crisis when it happens.
RK2 was first isolated in connection with an outbreak of antibiotic-resistant Pseudomonas aeruginosa and Klebsiella aerogenes in Birmingham in 1969, as one of a family of plasmids implicated in transfer of ampicillin resistance between bacterial strains. Plasmids in the IncP-1 subgroup has been isolated from wastewater, agricultural soil, and hospitals. RK2 is approximately 60 kbp long and contains genes for replication, maintenance, conjugation and antibiotic resistance. The resistance genes confer resistance to the antibiotics kanamycin, ampicillin and tetracycline. In addition, RK2 contains a set of potentially lethal (to the cell) genes, called kil genes, and a set of complementary transcriptional repressor genes, called kor (short for "kil-override") genes, which inactivate the kil genes. The kil and kor genes together are suspected to play a role in the broad host range of RK2.
AST is similar to alanine transaminase (ALT) in that both enzymes are associated with liver parenchymal cells. The difference is that ALT is found predominantly in the liver, with clinically negligible quantities found in the kidneys, heart, and skeletal muscle, while AST is found in the liver, heart (cardiac muscle), skeletal muscle, kidneys, brain, and red blood cells. As a result, ALT is a more specific indicator of liver inflammation than AST, as AST may be elevated also in diseases affecting other organs, such as myocardial infarction, acute pancreatitis, acute hemolytic anemia, severe burns, acute renal disease, musculoskeletal diseases, and trauma. The elevated AST level in hemorrhagic fever caused by crimean-congo hemorrhagic fever virus is associated with high mortality rate. AST was defined as a biochemical marker for the diagnosis of acute myocardial infarction in 1954. However, the use of AST for such a diagnosis is now redundant and has been superseded by the cardiac troponins. Laboratory tests should always be interpreted using the reference range from the laboratory that performed the test. Example reference ranges are shown below:
In its oxidized form, azurin (Cu2+Az) receives an electron from its redox partner and is reduced according to the following reaction: Cu2+Az + e− → Cu+Az The redox potential is 310 mV. The highly interconnected beta-sheet structure of azurin is strongly coupled with its electron-transfer center (the copper-binding side). Considerable experimental evidence exists to suggest that hydrogen bonds play a role in the long-distance electron transfer mechanism of azurin. Taken together, these observations suggest that electrons tunnel through the protein along its polypeptide and hydrogen bonds, making azurin a useful model system for studying long-range, intraprotein electron transfer (LRET).
Sources: en.wikipedia.org
Benazepril (Lotensin) Cilazapril (Inhibace) Enalapril (Vasotec/Renitec/Berlipril/Enap/Enalapril Profarma) Imidapril (Tanatril) Lisinopril (Listril/Lopril/Novatec/Prinivil/Zestril, Lisidigal) Moexipril (Univasc) Perindopril (Coversyl/Aceon/Perindo) Quinapril (Accupril) Ramipril (Altace/Prilace/Ramace/Ramiwin/Triatec/Tritace/Ramitac) Trandolapril (Mavik/Odrik/Gopten) Ceronapril (never marketed) Fosinopril (Fositen/Monopril) ACE inhibitor peptides can be derived from natural sources such as algae, fruit, seeds, dairy and animal products. A comprehensive resource on anti-hypertensive peptides is available in the form of a database. It contains around 1700 unique antihypertensive peptides. Arfalasin (HOE 409) is an angiotensin antagonist.
The molecular weight of c7orf26 is 50 kilodaltons. The isoelectric point is 7.61. The protein sequence is uniquely rich for leucine at 15.8% of its composition, this may indicate a leucine-zipper. Further analysis from PSORT indicates that a leucine-zipper region is found at amino acid 318 and lasts until position 340 (22 amino acids long). There are no extremes with regards to acidity and alkalinity. c7orf26 has a positive charge cluster from amino acid 245 – 275 and does not have any negative, or mixed charge clusters. An even distribution of amino acids compose c7orf26. The percent composition of each amino acid is fairly consistent throughout the orthologs of the protein. The most distant ortholog displays the most variance in amino acid composition. There is a higher percent composition of tyrosine, histidine and leucine and a lower composition of valine and alanine.
AHCC is widely used in the world and many people use it for general health maintenance and treatment of various diseases. It is often used as a complementary and alternative medicine (CAM) for immune support, as reports in animal and clinical settings have indicated that AHCC is associated with an enhanced response to infection and increased survival. AHCC is in some cases also used by those undergoing conventional cancer therapy (e.g. chemotherapy) for its reported immunomodulatory functions. In Japan, AHCC is the 2nd most popular complementary and alternative medicine used by cancer patients. Agaricus blazei supplements are the most popular, outpacing AHCC use by a factor of 7:1.
No chromosome translocations, chimeric genes, or fusion proteins have been described in BIA-ALCL although the neoplastic cells in the disease have been described to have gene copy number variations involving gains in gene copies on the p arm of chromosome 19 and losses of gene copies in the p arms of chromosome 10 and 1. The neoplastic cells in BIA-ALCL show mutations of the STAT3 gene in 64% of cases and reports of mutations in JAK1, JAK3, DNMT3A, and TP53 genes. The development of BIA-ALCL, it has often been suggested, may be at least in part a T-cell-induced, inflammation-driven cancer response to the implant.
Sources: en.wikipedia.org
Before amylin deposition was associated with diabetes, already in 1901, scientists described the phenomenon of "islet hyalinization", which could be found in some cases of diabetes. A thorough study of this phenomenon was possible much later. In 1986, the isolation of an aggregate from an insulin-producing tumor was successful, a protein called IAP (Insulinoma Amyloid Peptide) was characterized, and amyloids were isolated from the pancreas of a diabetic patient, but the isolated material was not sufficient for full characterization. This was achieved only a year later by two research teams whose research was a continuation of the work from 1986.
The Society recognizes achievements and promotes academic research through four annual awards. The Biemann Medal and the John B. Fenn Award for a Distinguished Contribution in Mass Spectrometry both are awarded in recognition of singular achievements or contributions in fundamental or applied mass spectrometry, with the Biemann Medal being focused on individuals who are early in their careers. The Ronald A. Hites Award is awarded for outstanding original research demonstrated in papers published in the Journal of the American Society for Mass Spectrometry. The Research Awards are given to young scientists in mass spectrometry, based on the evaluation of their proposed research. The Fellows of ASMS are awarded to individuals in recognition for their scientific contribution to mass spectrometry and for their contribution to the ASMS community. Journal of the American Society for Mass Spectrometry Measuring Mass: From Positive Rays to Proteins The past presidents of ASMS are:
Several methods have been used to determine the mechanisms of antimicrobial peptide activity. In particular, solid-state NMR studies have provided an atomic-level resolution explanation of membrane disruption by antimicrobial peptides. In more recent years, X-ray crystallography has been used to delineate in atomic detail how the family of plant defensins rupture membranes by identifying key phospholipids in the cell membranes of the pathogen. Human defensins have been thought to act through a similar mechanism, targeting cell membrane lipids as part of their function. In fact human beta-defensin 2 have now been shown to kill the pathogenic fungi Candida albicans through interactions with specific phospholipids. From the computational point of view, Molecular Dynamics simulations can provide detailed information about the structure and dynamics of the peptide-membrane interactions, including the orientation, conformation, and insertion of the peptide in the membrane, as well as specific peptide interactions with lipids, ions and solvent.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.
AEDG is the one-letter code for the four amino acids alanine, glutamate, aspartate and glycine in that order. The same molecule is written in three-letter form as Ala-Glu-Asp-Gly.
Identity is normally confirmed by mass spectrometry against the calculated mass of roughly 390.35 g/mol. Purity is then estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection.
Reversed-phase high-performance liquid chromatography with ultraviolet detection at 214 nanometres is the usual approach. Peak area percentage provides a purity figure relative to other components in the sample. Mass spectrometry is then applied to confirm identity.